TEKNECMIX · PNEUMATIC & ELECTRIC INDUSTRIAL MIXERS
TEKNECMIXINDUSTRIAL MIXINGRequest a quote ↗

Electric Clamp-Mount Drum Mixer — 400 W, 0–400 RPM

TEKNECMIX offers a 400 W electric clamp-mount mixer for open-head drum applications, with variable speed from 0 to 400 rpm, an 880 mm shaft and three 140 mm dispersing impellers. Single-phase 220 V / 50 Hz and 110 V / 60 Hz versions are available. Select the supplied electrical version, plug, wetted materials and clamp arrangement for the installation.

Product features

  • 400 W electric motor; single-phase 220 V / 50 Hz or 110 V / 60 Hz versions. No air compressor required. Motor thermal overheat protection.
  • Variable speed: 0–400 rpm for controlled low-speed mixing. Select the operating speed for the actual liquid to limit unwanted foaming and splashing; results depend on the process.
  • Clamp-mount bracket attaches to the rim of open-head steel or plastic drums. Confirm rim fit, support strength and the supplied clamp before installation.
  • 304 or 316 stainless steel wetted shaft and three dispersing impellers. Check chemical compatibility against the formulation, concentration, temperature and cleaning process.
  • Shaft length: 880 mm (88 cm / 34.6 in). Impeller diameter: 140 mm (14 cm / 5.5 in). Reference container: 200 L (52.8 US gal); check actual 55 US gal drum dimensions.
  • For application review involving open-head drum mixing, chemical batching, water treatment and coatings. This configuration is non-explosion-proof; do not select it for a classified hazardous atmosphere.

Technical specifications

04 — Electric clamp-mount open-head drum mixer
Specification Details
Drive and power 400 W electric motor
Electrical versions Single-phase 220 V / 50 Hz or 110 V / 60 Hz; confirm the voltage-specific version and plug
Variable speed 0–400 rpm
Mounting Clamp mount for the rim of an open-head steel or plastic drum; confirm fit and support strength
Reference drum volume 200 L (52.8 US gal); check actual 55 US gal drum dimensions
Shaft length 880 mm (88 cm / 34.6 in)
Impellers Three dispersing impellers; diameter 140 mm (14 cm / 5.5 in)
Wetted materials 304 or 316 stainless steel shaft and impellers; specify the supplied version
Motor protection Thermal overheat protection
Air supply No air compressor required
Explosion protection Non-explosion-proof
Applications for review Open-head drum mixing, chemical batching, water treatment and coatings; confirm material compatibility and mixing duty

Applications and mixing result

Send the actual formulation and mixing objective for chemical batching, water-treatment or coating applications. Speed selection, liquid properties, fill level and impeller arrangement influence mixing, foaming and splashing. Agree on trial conditions where the result needs to be demonstrated.

Installation and safety

Confirm the drum rim, support strength, working volume and impeller clearances. A 200 L drum is approximately 52.8 US gallons; a 55 US gallon drum is approximately 208 L, so the capacity name alone does not establish fit. This electric configuration is non-explosion-proof and must not be selected for a classified hazardous atmosphere.

For selection and quotation, send the liquid, viscosity at operating temperature, density, working volume, drum drawing or opening dimensions, available utilities, quantity and destination. Request a mixer quote.

Foshan Juxing Intelligent Technology Co., Ltd. · sales@teknecmix.com